Connection; Connection Diagram; Connection Specifications; Commissioning - SLAT Classic 75W Notice D'utilisation

3. Connection

3.1. Connection diagram

75 W wiring
* The cable tie included with all the products allows the mains cable to be secured to the mains terminal strip.
Important: the openings provided in the cabinet must be used. Do not create additional openings as
doing so may casue the device to malfunction and voids the warranty.
Core use table
C6-C7-C23-C24
75 W None
100-150 W OUTPUT CORE to be
installed

3.2. Connection specifications

Mains
Batteries
Load

4. Commissioning

Open the battery fuse.
After the electrical connections are made (mains, loads and batteries).
1. Close the upstream mains circuit-breaker.
2. Check the load output voltage. The LED on the motherboard is green.
3. Close the battery fuse.
4. Connect the earth wire (if equipped).
5. Close the cover.
C38
None
OUTPUT CORE pre-
installed
26
100-150 W wiring
C48
xxxx
OUTPUT CORE to be
75 W
2.5 mm²
2.5 mm²
2.5 mm²
F3U
None
installed
100-150 W
2.5 mm²
6 mm²
6 mm²