Agu PMBF2 Mode D'emploi page 60

6. Press the button
Spilt water should be poured from the water tank.
Note: when you press the button
temperature will pour out into the tank without adding a formula.
7. Click the button
amount of the ready formula quantity from 30 ml to 300 ml.
8. Press the button
formula preparation using the buttons
9. Press the button
preparation program for a given volume of water with the buttons
formula preparation», page 60).
ATTENTION
•
Use ONLY boiled water of room temperature.
•
Do not add water that is above 45°C.
•
Use only baby (bottled) boiled water!
10
OPERATING PRINCIPLES AND PROCEDURE
BABY FORMULA PREPARATION
1. Before operating the device, check the powder in the tank.
ATTENTION
In the container should be at least 30–40 grams of the mixture for the
correct preparation of the formula.
2. Fill the water tank. The volume of water must be more than the volume
of the prepared formula. The temperature of the water should be several
degrees below the formula preparation temperature; otherwise, the
machine will be in a standby mode until the water cools. In this case, the
indicator of the button «Warm water» will flash. For correct operation of the
formula, use baby (bottled) boiled water at room temperature, about 25°C.
3. Set the container for the prepared formula under the funnel. If the
container for the prepared formula is too high and does not fit into the
space between the funnel and the tray, remove the grate of the pallet;
install the container for the prepared formula without the grate.
60
several times to fill the system with water.
. Use the buttons
and then set the necessary temperature of the
a third time and set the desired formula
from 1 to 9. Now you can prepare the formula (see «Baby
, the water of set volume and
to set the necessary
from 25°C to 50°C.