Setting Up Your Side-By-Side Refrigerator; Installation Requirements; Enclosure Dimensions - Samsung RS27FDBTNSR Série Manuel D'utilisation

Setting up your side-by-side
refrigerator

INSTALLATION REQUIREMENTS

The installation location you choose must meet the
requirements listed in this section.
Selecting an installation place
• Check the refrigerator's dimensions in the table
below before you begin to install it and confirm
it can clear all the doors on its way to the
installation location.
- If the refrigerator cannot clear the doors, you
cannot install it.
Front and side dimensions
Model A
48"
RS27FDBTNSR/*
(1219 mm) (724 mm)
Door 90º Open
Dimensions with doors open
Model A B
44.5 52.5
RS27FDBTNSR/*
(1129 mm) (1333 mm)
18_ setting up
DA68-02935A-04.indb 18
(inches)
B C D E
28.5 82 92.1 85.9
(2083 mm) (2340 mm) (2182 mm)
Door 130º Open
(inches)
C D E F
40.6 14.4 20.1 46.3
(1032 mm) (365 mm) (510 mm) (1176 mm)
• Allow sufficient space on
the right, left, back, and
top for air circulation.
- If there is not enough
space, you cannot install
the refrigerator.

Enclosure dimensions

Model A
48
RS27FDBTNSR/*
(1219 mm)
• Confirm that the floor is flat.
- If the refrigerator is installed on
an uneven floor, it will cause
vibration and noise.
• Confirm that the floor can
support the weight of the
refrigerator and the food inside
(1102.3 lb (500 kg) total).
• Confirm that the refrigerator will
be within reach of a grounded
wall outlet.
• If the refrigerator is a dispenser
model, confirm that it will be
within easy reach of a water
supply and that the humidity in
the location is low.
- The refrigerator needs easy
access to a water supply for the
water and ice dispensers.
Location of
Electrical
Receptacle
Water Supply
Opening (20x20)
(inches)
B C
83.5 Min,
27.6
84.3 Max
(701 mm)
(2121 mm Min,
2141 mm Max)
2014. 5. 14. 9:38