Equipment Purpose; Usage Limitations - Leb electronics CTR58 Manuel D'emploi

ENGLISH
A) Equipment purpose
Electric board assigned to the control of 1 motor powered by 24Vcc voltage, allotted to the automation of a sliding gate.
B) - Usage limitations
Warning: Before putting in use the electronic equipment make sure the following notes are respected.
Note 1 - Carefully and thoroughly read the following technic documentation.
Note 2 - The electronic board should be installed but by qualified staff having got necessary technical and professional requirements.
Note 3 - Mains power supply in input to electric transformer should be equal to 230Vac +/- 10%.
Note 4 - The pole N (neutral) of mains power supply should be equipotential with ground.
Note 5 - All safety rules on installation of electrical devices must necessarily be respected.
Note 6 - Mains power should be supplied through an efficient differential switch tested and adjusted on the base of required rules.
Note 7 - The equipment should be assigned but to the use for which it was specially conceived (see point A). Any other usage is to be held as
improper and therefore dangerous.
Note 8 - Before handling on the electronic board, make sure there is not Mains power.
Note 9 - Don't handle the equipment with wet or damp hands or feet.
Note 10 - Don't let the equipment exposed to weather agents (rain, snow, etc.).
Note 11 - Don't let the equipment be handled by children or incompetents.
Note 12 - The electronic equipment should be lodged in its special housing.
Note 13 - It is necessary to install the equipment in a well airy room far from elements able to generate flames.
Note 14 - Ordinary maintenance of the equipment is to be performed but by qualified staff any 6 months.
Warning: If above mentioned notes are not respected, there can occur damages to people, animals or things, towards which the
manufacturer is not to be held as responsible.
13