teutonia Mistral S V3 Mode D'emploi page 14

Safety bar
Push the insert pieces on the safety bar through the
slots in the seat cover into the receptacles beneath,
which are located in the armrests. Make sure that the
safety bar has clicked into place on both sides. To re-
move it, press the release buttons on the insert piec-
es. In order to make it easier for your child to get in
and out, it suffices to release and fold up one side of
the bar.
Special features of the model variations
justment screw on the brake lever.
Note: The brake should only be used to slow the
wheels, not to block them.
Warning: When reordering rear wheels, please ensure
that the supplier is aware of the deceleration brake as
the brake requires a special brake disc. The foot brake
will not function if the wrong brake disc is used!
Maintenance:
-
The brake pads can wear out during use and the
brake needs maintenance. The setting of the brake
can be done on the brake lever when the lock nut is
loosened and the adjusting bolt is unscrewed.
-
If the left and right braking effect differs, tilt over the
stroller on soft ground and adjust the bolt under the
brake housings near the wheels.
-
The bolt can be screwed and unscrewed by using an
8mm jaw wrench. Unscrewing the bolt increases the
braking effect. The setting has to be made so that
the braking effect is the same on both wheels.
14
Models with deceleration
brake:
You are able to control the
deceleration brake using
the brake on the handlebar.
The braking action can be
fine-tuned using the ad-
Adjusting the straight-running stability
Shade holder on pram