teutonia Mistral S V3 Mode D'emploi page 11

Rain Cover
In rainy weather fit the rain cover over the entire
stroller/pram before it starts to rain.
Caution: The rain cover is not a toy! Never leave your
child unsupervised. For the best possible ventilation
of the stroller/pram we recommend using the rain
cover only for the duration of the rain shower. Do not
use raincover on a pushchair, carrycot, or carseat not
fitted with a hood
Removing the hood cover
Before washing, both hood bars must be removed
from the cover.
Loosen the screw with a screwdriver and remove the
snap. Now pull the cover bar out of the joint and out of
the hood cover. After washing, reassemble in reverse
order.
Make sure that each cover bar is pushed into one of
the stitched guides. The front and back bars must not
be mixed up.
Unfolding the Chassis
Folding the Chassis
the foot step 3 on the right-hand side of the stroller
has been pushed. You can reduce the storage size
further by folding down the top of the handle.
Pull up the folding handle 1
(hand grip) till it locks in
one sharp movement so
that both handle ends 2
fully engage in the left and
the right lock.
WARNING: Ensure
that all the locking
devices are engaged
before use.
Pivot the folding handle to
the side with the locking
rods. Now pull the two un-
locking rods on both sides
1 up -wards and press the
slide forwards. The chassis
is folded up to the arrester
2, which prevents inadvert-
ent folding. The chassis
does not fully fold unless
Mounting and removing the wheels
Rear wheels:
To detach the rear wheel:
– Press the locking (7) and pull the wheel off the axle.
To attach push the wheel onto the axel.
Check that the wheel is proparly locked by pulling!
Front wheels:
To detach press the locking (10) and pull the steering
axle out. To attach, push the axel into place.
Check that the wheel is proparly locked by pulling!
11