GVB MultiCap-Flat Notice D'utilisation page 16

MultiCap user manual
2. Put the electrodes onto the desired positions.
For this, press down the electrode into the
electrode- body until it´s be fixed.
3. In order to raise the contact-surface, use a
conductive gel like "NEURGEL", or for long time
recordings the "SYNAPSE" gel that you can fill
with the provided blunt needle kit into the
intended gap of the electrode.
Electrodes and impedances
1. In order to minimize the impedance, the
electrode position on the scalp should be
prepared. We recommend the abrasive gel
"EVERY" or "NUPREP" which both have very
good qualities
user-friendly basecut of the MultiCap, all
electrode positions can be reached quite simply.
2. Put the electrodes onto the desired positions.
Place the electrode on the wide part of the holder
(photo)
3. In order to raise the contact-surface, use a
conductive gel like "NEURGEL", or for long time
recordings the "SYNAPSE" gel that you can fill
with the provided blunt needle kit into the
intended gap of the electrode.
16
(MultiCap-Cup)
for preparation. By the
CAP CAP