Yardworks 060-0583-8 Manuel De L'opérateur page 18

model no. 060-0583-8 | contact us: 1.866.523.5218
PROBLEM
The handle is not in position.
The snowblower does not start.
The motor is on, but the impeller
does not turn
The snowblower leaves a thin layer
of snow behind
POSSIBLE CAUSE
The bolts are not properly seated.
The switch is defective.
The extension cord is not connected
to the plug.
The extension cord is not connected
to the power source.
The belt is damaged.
The scraper is worn.
SOLUTION
Make sure the bolts are correctly
installed through the handle bars.
Check to see if the hand knobs
are tight. Refer to Assembling the
Handle, page 9.
Have the switch replaced by an
authorized service centre.
Connect the plug on the snowblower
to the extension cord.
Plug the extension cord into a live
120 V AC, 60 Hz outlet.
Replace the belt. Refer to Replacing
the Belt and Pulley, page 15.
Inspect the scraper for wear or
damage. Replace the scraper. Refer
to Replacing the Scraper Bar, page
15.
17
®
/MD