Operation; Remote Control; Installing The Remote Control Batteries; Using The Remote Control - CYBEX CP-21072 Manuel D'instructions

REMOTE CONTROL

Installing the Remote Control Batteries

Remove the battery cover from the remote control and install 2 x AAA size batteries (provided) inside the compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.

Using the Remote Control

To use the remote control, point it towards the sensor located on the front bottom of the monitor. Operate all functions
using the remote control. NOTE: The power switch is for standby mode only. It does not turn power on and off.
3 – Operation
Standby – Press to toggle the monitor standby mode on and off.
Mute – Press to toggle audio mute on and off. Press the VOL+
will also switch mute off.
Numeric Keypad – Press 0-9 to directly select a specifi c
channel.
Sub Channel Number Key – Press to enter a sub channel
number. Example: Channel 4-1.
Return to the Last Channel Key – Press to return to the last
channel viewed.
Volume +/- keys – Press to increase or decrease volume.
MTS – Press to select audio channels. Stereo or Mono.
CC – Press to set closed captioning On or Off.
Channel +/- keys - Press to increase or decrease channels.
Press and hold to scan quickly.
EPG - Press to enter the EPG (Electronic Program Guide)
menu. NOTE: EPG is Subject to availability from broadcaster/
cable supplier.
Arrow Keys and Enter – Press to navigate the on screen
menus and adjust the system settings to preference.
LCD MENU – Press to enter Menu and adjust settings or tuning.
EXIT – Press to clear all on-screen displays and return to
monitor viewing.
3-1