Operation; Remote Control; Installing The Remote Control Batteries; Using The Remote Control - CYBEX CP-21073 Mode D'emploi

REMOTE CONTROL

Installing the Remote Control Batteries

Remove the battery cover from the remote control and install 2 x AAA size batteries (provided) inside the compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.

Using the Remote Control

To use the remote control, point it towards the sensor located on the front bottom of the monitor. Operate all functions
using the remote control. NOTE: The power switch is for standby mode only. It does not turn power on and off.
3 – Operation
Standby – Press to toggle the monitor standby mode on and
off.
Mute – Press to toggle audio mute on and off. Press the VOL+
will also switch mute off.
Numeric Keypad – Press 0-9 to directly select a specifi c
channel.
1/2 Digits – Press to toggle between 1 or 2 digits for analogue
channel number.
Return to the Last Channel Key – Press to return to the last
channel viewed.
Volume +/- keys – Press to increase or decrease volume.
NICAM – Press to select audio channels. Stereo or Mono.
Info – Press to display the channel information.
Channel +/- keys - Press to increase or decrease channels.
EPG - Press to enter the EPG (Electronic Program Guide)
menu. Subject to availability from broadcaster/cable supplier)
Arrow Keys and Enter – Press to navigate the on screen
menus and adjust the system settings to user's preference.
LCD MENU – Press to enter Menu and adjust settings or tuning.
EXIT – Press to clear all on-screen displays and return to
monitor viewing.
3-1