Install Monitor - CYBEX CP-21072 Manuel D'instructions

3. Install Monitor

WARNING: To prevent injury, this apparatus must be securely attached to the mounting bracket in
accordance with these installation instructions.
NOTE: Refer to the appropriate Cybex A/V installation instructions before performing the steps listed below.
A. Locate monitor (A). See Figure 2.
A
Tabs (2)
Figure 2
B. Remove the back cover by pressing in the two tabs
at the base of the monitor (A) and rotating the back
cover up and off of the monitor (A). See Figure 2.
C. Using an 11mm socket wrench, remove the six nuts
mounted to the monitor (A). See Figure 3.
A
Figure 3
D. Using an 11mm socket wrench, secure the monitor
(A) to the monitor bracket using the six nuts
removed in step 3C. See Figure 3.
5-2
Back
Cover
Nuts (6)
Monitor
Bracket
E. Locate the power cable, composite video cables,
coax cable, blue RJ-45 cable and green RJ-45
cable exiting the back of the console. See Figure 4.
Figure 4
F. Insert the power cable, composite video cables,
coax cable, blue RJ-45 cable and green RJ-45
cable into the monitor (A) as shown in Figure
5. NOTE: Composite video cable inlets vary by
monitor. Ensure cable color matches inlet color.
Composite
Video
Cables
A
Power
Cable
Figure 5
Blue
RJ-45
Coax Cable
Green
RJ-45