Troubleshooting - Braun Silk-expert Pro 3 6032 Mode D'emploi

  Troubleshooting
Problem
Power bars do not light up when treatment window
is placed on the skin.
The device doesn't work on small areas.
With the precision head attached, the flashing
sequence is slower.
On the power bar, only the first LED illuminates
red.
Center gentle mode light is flashing.
First LED on power bars flashes red.
The power bars show an unfamiliar pattern of one
red LED shining along with individual white LEDs.
All white LEDs flash.
The device is broken, cracked or appears
defective.
Solution
Make sure the device is connected to an electrical
outlet. Press any button to activate it.
Ensure both skin tone sensors are in full contact
with the skin. If needed, move the device in a way
that both skin tone sensors get skin contact.
Use the precision head (if available) on small,
hard-to-reach areas. Make sure both skin tone
sensors are in contact with the skin.
This is normal.
Invalid skin tone reading. Your skin is too dark.
For safety reasons, the device will not flash.
Device is deactivated. Press any button to
re-activate it.
Head (10 or 11) has been taken off. Re-attach it.
Device error. Device will not operate.
Unplug and re-connect.
If error persists, contact a Braun Service Center.
End of product lifetime. Maximum number of
flashes (300,000) has been reached.
DO NOT USE if the handle, the base station or the
mains cord is damaged.
13