Treatment Modes - Braun Silk-expert Pro 3 6032 Mode D'emploi

c) Press the treatment button (5). The device will flash and a warm sensation should be felt.
If you find the treatment uncomfortable, you may reduce the light intensity using the gentle mode
button (4). The gentle mode indicator lights up when it is activated. To deactivate it, press the gentle
mode button again.
The power bars flash to confirm a change in the light intensity setting.
When holding the gentle mode button (4) longer than 3 seconds, the device is deactivated.
After 10 minutes without use, the device is automatically deactivated. To re-activate, press
any button.
d) Move the treatment window to the next area to be treated and repeat. The device needs to recharge
between flashes. This will take less than a second.
e) Ensure that the entire area receives treatment, but DO NOT treat an area twice (overlapping flashes).
If the device is used in high ambient temperatures for extended treatment sessions, short pauses in
treatment may be seen to allow cooling. This is normal and operation will resume once the device is
cooled.

8 Treatment Modes

The area to be treated has to be hair-free, clean and dry. Before pressing the treatment button, look away
from the device to avoid the bright light. In seldom cases, a user may find the flash too bright, however
there is no safety risk associated with this. For increased comfort, we recommend treating in a well-lit
room to help reduce the perceived brightness.
GLIDING
for fast and efficient
treatment of large areas
(e.g. legs).
1. Place the treatment window (1) firmly on your skin, ensuring both skin sensors (2) have skin contact.
Power bars (3) show white LEDs.
2. Press and hold the treatment button (5).
The device will begin to flash.
3. Move the device slowly and continuously from the
bottom to the top of the treatment area to avoid
missing areas. Make sure to always keep full skin
contact so that the device flashes continuously.
Once you have completed your first gliding stroke, lift
the device off the treatment area. Repeat steps 1 to
3 to treat the next adjacent area in a parallel stroke.
Make sure to avoid missed areas by placing the treatment window directly next to the previously
treated spot without leaving any space between treated areas.
If you feel intense pain, stop treatment immediately and consult your physician before using the device again.
Treatment head(s)
While the standard head (10) can be used on all areas, it is ideal for efficiently
treating large areas, e.g. legs.
The precision head (11) (not with all models) has been specifically designed
for small, curvy, hard to reach areas, e.g. face for females, bikini line, underarms,
knee, shin, ankle.
STAMPING
for treating small,
hard-to reach areas
(e.g. face for females,
bikini line, underarms,
knee, chin, ankles)
2. Press and instantly release the treatment
button (5). The device will emit a flash.
3. Lift off the device and place it onto the next
adjacent spot to be treated. Wait for the
power bars to show white LEDs. Then press and
release the treatment button.
Continue treatment spot by spot until you have
completed the entire area you wish to treat.
11