Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SYMBOLS
Warning
Read and follow all safety
precautions in the owner's manual
Failure to follow to instruction could
result in serious injury to user.
Protective goggles/visor ,protective
helmet & hearing protetction
Gloves with saw protection
Boots with saw protection, steel toe-
cap and non-slip sole
Correct Direction of Cutting-Teeth
Chain brake
Tip contact may cause the guide
bar to move suddenly upward
and backwards, which may cause
serious injury to user.
Contact of the guide bar tip with any
object should be
Do not use one handed when
operating the chain saw.
Always use two hands when
operating the chain saw.
Double insulation.
When servicing, use only identical
replacement parts.
The chain saw kickback angle is 10º,
10º
with a chain brake.
Electric chain saw
ASSEMBLY
wARNING! Do not connect the
chain saw to mains before it is
completely assembled.
Always use gloves when handling the
chain.
CHAIN AND CHAIN BAR ASSEMBLy
1. Unpack all parts carefully.
2. Place the chain saw on any suitable flat
surface.
3. use only genuine wORX chains
designed for chainbar.
4. Slide the chain (8) in the slot around the
chain bar (7). Ensure chain is in correct
running direction by comparing with chain
symbol (14). Ensure the chain tensioning
catch (18) is facing outwards. (See Fig. A2)
5. Fit the chain onto the drive sprocket (13)
and guide the chain bar (7), so that the
fastening bolt (17) and the two guide fins
(15) fit into the keyway of the chain bar(7).
(See Fig. B)
6. Check if all parts are seated properly and
hold chain and chain bar in a level position.
(See Fig. C1)
7. Fit cover plate, ensure that the chain catch
bolt (20) fits into the groove of the cover
plate(11). (See Fig. C2)
8. Screw on the cover plate (11) with the
locking knob (10). (See Fig. D)
The chain is not yet tensioned. Tensioning
the chain applies as described under
"Tensioning chain" .
tENSIONING CHAIN
New saw chains will stretch. Check chain
tension frequently when first used and tighten
when chain becomes loose around chain bar.
wARNING: unplug chain saw from
power source before adjusting saw
chain tension.
wARNING: Cutting edges on chain
are sharp. use protective gloves
when handling chain.
wARNING: Maintain proper chain
tension always. A loose chain will
increase the risk of kickback. A loose
chain may jump out of guide bar groove.
this may injure operator and damage
13
13
En
Publicité
Table des Matières
