Worx WG300 Mode D'emploi page 10

t) Replacement Saw Chain – A chain that
complies with the kickback performance
requirements of ANSI B175.1-1991 when
tested with specific chain saws. It may not
meet the ANSI performance requirements
when used with other saws.
u) Chain(8) – A loop of chain having cutting
teeth, that cut the wood, and that is driven
by the motor and is supported by the guide
bar.
v) Gripping teeth (Spike)(9) – The pointed
tooth or teeth for use when felling or
bucking to pivot the saw and maintain
position while sawing.
w) On/Off switch (2)– A device that when
operated will complete or interrupt an
electrical power circuit to the motor of the
chain saw.
x) Switch linkage – The mechanism that
transmits motion from a trigger to the
switch.
y) lock-off button(3)– A movable stop that
prevents the unintentional operation of the
switch until manually actuated.
FOR ALL DOuBLE-INSuLAtED CHAIN
SAwS
1) Replacement Parts
10 10
When servicing use only identical
replacement parts.
2) Polarized Plugs
To reduce the risk of electric shock, this
equipment has a polarized plug (one blade
is wider than the other). This plug will fit
in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
FOR ALL CHAIN SAwS
1) Keep work area clean.
Cluttered areas invite injuries.
Do not start cutting until you have a clear
work area, secure footing, and a planned
retreat path from the falling tree.
2) Consider work area environment.
Use extreme caution when cutting small
size brush and saplings because the
slender material may catch the saw chain
Electric chain saw
and be whipped toward you or pull you off
balance.
Do not operate a chain saw in a tree unless
specifically trained to do so.
When cutting a limb that is under tension
be alert for spring back so that you will not
be struck when the tension in the wood
fibers is released.
Don't expose chain saw to rain.
Don't use chain saw in damp or wet
locations.
Do not use chain saw in presence of
flammable liquids or gases.
3) Protect yourself against electric shock
Prevent body contact with grounded
surfaces. For example: metal pipes, wire
fences.
4) Keep children away
Do not let visitors contact the chain saw or
extension cord.
All visitors should be kept away from work
area.
5) Store idle chain saw
When not in use, chain saws should be
stored in a dry, and high or locked-up place
– out of the reach of children.
When storing saw, use a scabbard or
carrying case.
6) Don't force chain saw
It will do the job better and safer at the rate
for which it was intended.
7) Use right tool
Cut wood only.
Don't use chain saw for purpose not
intended – for example – Don't use chain
saw for cutting plastic, masonry, non-wood
building materials.
8) Dress properly
Do not wear loose clothing or jewelry.
They can get caught in moving parts.
Rubber gloves and non-skid footwear are
recommended when working outdoors.
Wear protective hair covering to contain
long hair.
9) Use safety glasses/safety visor
Also use safety footwear; snug fitting
clothing; protective gloves; hearing and
head protection.
10) Carrying saw
Carry the chain saw by the front handle
En