LG LTCS20220 Série Mode D'emploi page 10

2. Reversing and Reinst alling Refrigerator Door
Using a ¼" socket wr ench, loosen and remove Hinge
Pin fr om the Middle Hinge Bracket. Remove washer
undernea th the middle hinge and set aside.
NOTE: At this point the door will be loose. Slightly lift the
door and remove it.
Loosen and remove the tw o bolts and use the Phillips
head screwdriver to remov e the Middle Hinge Bracket
from the refrigerat or housing. Set parts aside.
Remove the washer fr om the Bottom Hinge Pin.
Using a ¼" socket wr ench, loosen and remove the
Hinge Pin from the Bott om Hinge. Reattach the
Hinge Pin to the opposit e side of the hinge.
This is easier to do while the hinge is still
NOTE:
attached.
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION
Using a 3/8'' socket wrench with a 2-Inch extension
and screwdriver, loosen the two bolts and one screw, and
remove the Bottom Hinge from right side of the housing.
Remove the Decorative Caps on the bottom of the
refrigerator housing. You will need these holes for the
Bottom Hinge.
Move the Bottom Hinge to the left side of the housing,
keeping the same orientation, and reattach with the
two bolts and one screw. The flat screw must be
placed on the exterior side of the hinge. Move the
Decorative Bolt to the hole on the lower right side
of the housing.
Turn the refrigerator door upside down on a
nonsc
to remove the Bottom Hinge Pin Insert Bracket
with the Hingr Pin Insert.
the leveler to the opposite side.
NOTE:
9
Leveler
ratching surf ace. Loosen the two screws
WARNING:
If you reinstall or replace doors, move
The leveler is only present on some models.