Kuppersbusch KD 6500.1 Mode D'emploi page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Recirculation fitting
• The filtered air is returned to the room through the two plastic side grills G on the upper
chimney element S .
• Connect the pipe T to the round fan outlet, pushing it downwards, and fit spigot R in a
similar manner (make sure that the two additional side recirculation spigots P1 are fitted
to spigot R). Make sure that the height of the assembly R + T corresponds to the height
of the chimney outlet.(fig.6).
• Fit the activated charcoal filters inside the canopy (see paragraph on Maintenance ). Do
not fit the venting grilles until after the chimney has been installed.
Fitting the telescopic chimney
• To fit the upper section S first expand the two side pieces slightly, hook them behind the
brackets 2 and close them together again until they touch. Fix the upper section S to the
brackets 2 using four of the screws provided in the bag of accessories (fig.7).
• Fit the lower section I as above, between the upper section S and the canopy C.
• Chimney with venting grilles: Snap the venting grilles into position in the apertures located
on the chimney section, so that the symbol
faces forwards. Also, when the hood is used in recirculation mode, ensure that the grilles
are properly secured to the inside of the recirculation spigot R (fig.8).
8
is turned upwards and the symbol
GB

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kd 9500.1

Table des Matières