Applications; Safety Notes; Setting Up And Connecting The Unit; Remote Control - Monacor International img Stage Line FM-102DAB Mode D'emploi

GB
Digital Stereo Tuner for the
Reception of DAB+ and FM
Please read these operating instructions care-
fully prior to operation and keep them for later
reference.

1 Applications

The FM-102DAB is used to receive FM stations
and the "digital radio" DAB+ (Digital Audio Broad-
casting) in the band III (174.928 – 239.200 MHz).
For storing stations, 20 station numbers each are
available for FM and DAB reception.

2 Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains
voltage. Leave servicing to skilled
personnel only. Inexpert handling
or modification of the unit may
result in electric shock.
G
The unit is suitable for indoor use only. Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range: 0 – 40 °C).
G
Do not place any vessel filled with liquid on the
unit, e. g. a drinking glass.
G
Do not operate the unit and immediately dis-
connect the mains plug from the mains socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
G
For cleaning only use a dry, soft cloth; never
use water or chemicals.
G
No guarantee claims for the unit and no liabil-
ity for any resulting personal damage or mate-
rial damage will be accepted if the unit is used
for other purposes than originally intended, if it
not correctly connected or operated or if it is
not repaired in an expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment.
8
3 Setting Up and
Connecting the Unit
The unit can be installed in a rack (482 mm / 19")
by means of its mounting brackets, but may also
be used as a desktop unit. For installation in a
rack, one rack space (RS = 44.45 mm) is re -
quired.
Prior to making or changing any connec-
tions, switch off the tuner and the unit to be con-
nected.
1) Connect the RCA jacks OUTPUT located on
the rear side of the unit to the line signal input
of an audio unit (amplifier, active speaker
system, mixer, audio matrix router, etc.).
2) On the rear side of the unit, the jack
ANTENNA is available for antenna connec-
.
tion. The telescopic antenna provided can be
connected to this jack and fastened.
To obtain optimal reception of weak sta-
tions, align the antenna by means of the sig-
nal strength indication. To activate the signal
strength indication, press the button INFO
repeatedly until a bar graph appears on the
lowest display line.
3) For power supply, connect the mains jack to
a mains socket (230 V~ / 50 Hz) using the
mains cable provided.
4 Operation

4.1 Remote control

1) To insert the batteries (2 × 1.5 V, size AAA),
remove the battery compartment cover on
the rear side of the remote control. Insert the
batteries as indicated in the battery compart-
ment. Close the battery compartment with the
cover.
If the remote control is not to be used for a
longer period of time, remove the batteries to
prevent any damage due to battery leakage.
2) When pressing a button, point the remote
control at the sensor "IR". Make sure that
there are no obstacles between the remote
control and the sensor.
3) If the range of the remote control decreases,
the batteries are discharged and must be
replaced.
Discharged batteries must not be
placed in the household waste;
always take them to a special waste
disposal, e. g. collection container at
your retailer.
4.2 Tuner
1) Switch on the unit with the POWER switch.
/ will be appear on
Welcome! Digital Radio
the display; then the station most recently
selected will be indicated.
2) The operation options are listed in the table to
the right. Some settings can alternatively also
be made via a menu. Other settings can only
be made via the menu. Please refer to pages
10 and 11 for the menu structure. To call up
the menu, press the button MENU. All the
other steps are given in the figure.
The display will return from some menu
items to the indication of the station set if
none of the buttons MENU, DOWN, UP or
ENTER is pressed within a time period of
approx. 5 seconds.
3) During initial operation, first store the stations
that can be received at where you are
located. 20 station numbers each are avail-
able for FM and DAB+ reception.
5 Specifications
DAB+
Frequency received: . . 174.928 MHz to
239.200 MHz
Selectivity
to adjacent channel: . . ≥ 31 dB
to more remote
channels: . . . . . . . . . . ≥ 49 dB
Sensitivity: . . . . . . . . . . . −97 dB
FM
Frequency received: . . 87.5 – 108 MHz
Tuning increment: . . . . . . 50 kHz
Sensitivity: . . . . . . . . . . . 10 μV
Output level: . . . . . . . . . . 0.4 V
General information
Power supply: . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . 50 VA max.
Ambient temperature: . . . 0 – 40 °C
Dimensions: . . . . . . . . . . 482 × 44 × 210 mm,
1 RS (rack space)
Weight: . . . . . . . . . . . . . . 2.15 kg
Subject to technical modification.
All rights reserved by MONACOR ®
GmbH & Co. KG. No part of this instruction manual may
be reproduced in any form or by any means for any
commercial use.
INTERNATIONAL