Compex FIXX 1.0 Mode D'emploi page 6

OPERATING INSTRUCTIONS
1. Connect the charging plug to the battery charging base unit and plug into wall outlet. Place
battery on charging station. Charge 1.5-2.5 hours before use.
2. When battery is charging a red light appears. Once the battery is fully charged, a green light
appears (Refer to figure 1A and 1B).
3. Before use, make sure Fixx massager is off. Then, place the ball on to the metal shaft
with slight pressure until the shaft stops inside the ball. Turn clockwise until ball is secured in
place. The ball must be connected prior to operating the Fixx massager (Refer to figure 3A).
4. Fixx massager turns on when battery is inserted into massager. Making sure Fixx massager
switch is in the OFF position, slide battery into battery slot by pushing battery in until you hear
the tabs on each side click into place.
5. To turn on, slide switch on the upper handle forward until massager starts to run. Slide the
switch further forward to increase speed to three levels (1, 2, 3).
6. To rotate the arm, press the button on the circular housing. Arm can lock into 3 different
positions 0, 45, 90 degrees (Refer to figure 2B).
7. There are four indicator lights on Fixx massager body showing battery capacity of 25%, 50%,
75% and 100%. When the battery reaches 25% remove and place on battery charging base. To
ensure long battery life, try not to fully deplete the battery (Refer to figure 1A and 1B).
8. To remove battery, squeeze tabs on both sides of the battery and pull away from the
massager body.
9. To remove ball, turn Fixx massager off and turn ball counterclockwise and pull ball away from
the shaft. Use antibacterial or alcohol wipes to clean ball between uses.
6