Maintenance And Cleaning - T-Fal PRIMAGLIDE DIFFUSION FV22 Série Mode D'emploi

Masquer les pouces Voir aussi pour PRIMAGLIDE DIFFUSION FV22 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Obtaining more steam
Burst of Steam
Press the
stubborn wrinkles (
Vertical steam function
This is ideal for removing wrinkles in delicate garments, jackets, skirts, curtains, etc.:
Hang the garment on a hanger and hold the fabric slightly taut with one hand.
Set the temperature control dial to
Repeatedly press the
between each push, and continuously move the iron over the fabric (
Hold the iron a few inches from the fabric to avoid burning delicate fabrics.
When the auto-off warning
light is on, it is normal for the
temperature light to remain
off.
Storing your iron
Set the steam control lever to
Let the soleplate cool completely and empty the water tank. A small amount of water may remain in the water
tank.
Wrap the cord around the heel of the iron.
Store the iron on its heel (

Maintenance and cleaning

Unplug your iron and let it
cool completely before
cleaning it. The iron will not
function without the
anti-scale valve. Never touch
the end of the valve !
Cleaning the iron
In order to reduce scale build-up and extend the life of your iron, it is recommended that you use the Self-Cleaning
feature once a month, as noted below:
Unplug the iron, set the steam control lever to
Place the iron on its heel, set the temperature dial to
go out.
Unplug the iron and hold it horizontally over a sink.
Remove the anti-scale valve (
(depending on model)
button periodically to remove
fig 6
).
The
brics. Use this to remove stubborn wrinkles.
(depending on model)
MAX
(
Burst of Steam
button (
The iron is equipped with an electronic system that will automatically cut the
power source to your iron if it is left vertically on its heel for more than 8
minutes, on its soleplate for more than 30 seconds or on its side for more
than 30 seconds.
The auto-off warning light (
mode.
To restart the iron, gently shake the iron until the warning light stops
flashing.
and unplug the iron.
fig 10
).
It is recommended that you clean the anti-scale valve once a month to re-
move scale build up on the valve. Clean the anti-scale valve as noted below:
Unplug your iron and empty the water tank.
Remove the anti-scale valve (
Soak the valve (the black section only) in white vinegar or plain lemon
juice for 4 hours (
Rinse the valve under running water and replace the anti-scale valve in
the iron.
fig 11
).
Spray
fig 7
button (
fig 3
).
fig 6
) pausing a few seconds
3-Way automatic shut-off
fig 9
fig 12
).
and fill the water tank to
MAX
, plug in the iron and wait for the indicator light to
7
In order to achieve the maximum amount of
steam, it is recommended that you wait a
few seconds after you first push the Burst of
Steam button before pressing it again.
Spray Function
) will release a mist of water onto your fa-
Every fifth time you press the
button, return the iron to the
horizontal position.
The steam is very hot. When
using the vertical steam func-
tion, always iron with the
fig 8
).
garment on a hanger, never
while wearing it.
(depending on model)
) will flash when the iron is in the shut-off
Cleaning the anti-scale valve
fig 11
).
MAX
.

Publicité

Table des Matières
loading

Table des Matières