Grounding Instructions - Waring Commercial MMB145 Directives D'utilisation

13. Never place cutting assembly or cutting blades on base
without container properly attached.
14. Always operate blender with cover in place.
15. Always operate blender with jar pad in place.
16. CAUTioN: This blender is not intended for use with hot
liquids or ingredients.
17. Do not fill above MAX FiLL line for blending.
18. Not for waterjet cleaning.
19. Ensure the jar coupler and motor coupler are aligned
and engaged before operating. if unable to engage,
remove jar and shake contents, then try again.
20. The jar coupler and motor coupler may be hot after
running; do no touch.
21. Replace jar pad if worn with groove.
22. Always use hi speed for crushing ice.
23. if the jar overflows during blending, there is too much
liquid/ingredients in the jar. stop blending, remove
enough liquid/ingredients to below MAX Fill line, and
continue blending. Do not operate if overflowing.
SAVE THESE INSTRUCTIONS

GROUNDING INSTRUCTIONS

•   F oryourprotection,Waring
equipped with a 3-conductor cord set.
•  1 20voltunitsaresuppliedwithamolded3-prong
grounding-type plug and should be used in combination
with a properly connected grounding-type outlet, as
shown in Figure 1.
Commercial Blenders are
®
3