Led Indicator - Taurus HOMELAND GYRO Manuel D'utilisation

the time increases or decreases 1.
- Press the (AL) button in progress or stop the
robot will beep when the time setting is com-
pleted.
2) CONFIGURE THE CLEANING HOURS
- Press the (AM) button to select and the date
will start flashing. If you don't select a date,
the "SUN" indicator for the day of the week will
start flashing (SUN, MON, TUE, WED, THU,
FRI, SAT) .
- Press / button to change the date. After
setting, press the (AL) button to confirm and
enter the time setting.
- The hour will begin to flash, press
to adjust time, and press
ween hours and minutes. With each press, the
time increases or decreases 1.
- Press the (AL) button in progress or stop the
robot will beep when the time setting is com-
pleted.
3) CANCEL THE SETTINGS OF THE
CLEANING HOURS
- Press the (AM) button on the remote control
for 4 seconds, the vacuum cleaner will emit a
beep when the cleaning schedule confirmation
/ button
/ to switch bet-
is canceled.
4 sec.

LED INDICATOR

LED LIGHT
Flashing blue
Solid blue
Off
Blue light Flash
Fast/Blue and Red
light lash/Flashing
Red/Beep
MAINTENANCE
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washingup liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
ROBOT STATUS
Charging
Standby / Cleaning / Fully
charged
Robot is off. To conserve
power, the light automati-
cally turns off when robot
is not docked to the char-
ging doc and has been
inactive for 1 minute.
Robot has an error. Refer
to the troubleshooting
section "Anomalies" in this
manual for solutions