Led Panel; Product Operation; Battery Charging - Zoef Robot SR806W SJAAN Mode D'emploi

LED Panel

1. " ": LED panel
LED panel shows the time setting, charging status, and error codes by using numbers, letters
or graph.
Buttons
2. "MODE": Select the mode
Press, when Shaan must perform in specific task.
nod1: the robot goes 1x1 square meter through a zig-zag route.
nod2: the robot goes 2x2 square meters through a zig-zag route.
nod3: the robot goes 3x3 square meters through a zig-zag route.
nod4: the robot goes 1x1 square meter through a zig-zag route.
3. " ": Schedule button
In standby mode, press this button to enter/quit scheduling mode.
4. " ": Clean button
A. Press this button to change from sleeping mode to standby mode.
B. In standby mode, keep pressing this button for more than 3 seconds to go into sleep mode.
C. Confirm scheduling setting in scheduling mode.
D. Start cleaning in standby mode.
5. " ": Auto homing / Number increment button
A. Press this button to increase number in scheduling mode.
B. In other mode, press this button to start auto-homing and charging mode.
6. " WALL": Wall cleaning / Number decrement button
A. Press this button to decrease number in scheduling mode.
B. In other mode, press this button to start wall cleaning.

Product Operation

1. Battery charging

A. Positioning the charging station:
Place the charging station against the wall and
remove obstacles 1 meter on either side and about
2 meters front of the charging station, as shown in
the image.
B. To charge, make sure the "ON/OFF" switch on the side of the robot is switched to "ON".
C. Charge the robot in one of the two ways as shown below:
a. Plug the adapter into the robot and the other end to the power socket as shown in Fig.a.
7