Fagor BC-79 Manuel D'installation page 8

REVERSING THE DOOR HINGE
It is possible to reverse the door on this appliance, if
required.
To do so, follow the steps below:
Note: All parts removed must be
saved to do the reinstallation of door.
1. Remove the front ventilation grille
adjustable ventilation grille
○ ○
the screws
3 & 4
A E A A
NOTE: For model BC-79, the step of removing
the ventilation grille is not needed.
2. Remove the bottom hinge plate
unscrewing the four lock screws
to hold the glass door firmly after removing the
screws. (Fig. 2)
3. Gently pull down to remove the glass door from
the right top hinge and place it on a padded
surface to avoid the risk of damage. Then
remove the right top hinge
4. Unscrew and transfer the hinge pin of the
bottom hinge plate
5. Pop out the cover caps on the left side of
cabinet and use them to
on the right hand side.
6. Screw the alternative left top hinge
in the fittings, on the left hand side of cabinet.
(Fig. 4)
7. Rotate the door 180° and then relocate the door
to the designated position. Then screw the
bottom hinge assembly on the left designated
position and tighten it after the door is leveled.
(Fig. 2)
○
and the
2
A E A
○
by unscrewing
1
A E A
. (Fig. 1)
E A
○
5
A
○
. Make sure
6
A E A
○
. (Fig. 3 & 4)
7
A E A
○
to the opposite side.
5
A E A
cover the screw holes
○
, included
9
A E A
8. Reassembly the ventilation grilles.
NOTE: For model BC-79, the step of reassembling
the ventilation grille is not needed.
ATTENTION!
•
Do not overload the cabinet.
•
Do not open the door unless necessary.
•
Do not cover shelves with aluminum foil or any
other material which may prevent air circulation.
•
Should the beverage center be left empty for a
long period of time, we recommend you unplug
the appliance and after careful cleaning, leave
the door ajar to allow air to circulate inside the
cabinet
condensation, mold or odors from forming.
by
E A
8
in order to prevent possible