Fagor BC-79 Manuel D'installation page 10

Setting the Temperature Control
•
The unit has a single temperature zone. The
temperature can be set between 36ºF and 43ºF
(2ºC and 6ºC).
•
When the unit is plugged in for the first time, the
unit will power up automatically to the preset
defaults. The default temperature is 38ºF (3°C).
•
You can set the temperature by pressing the
UP and DOWN buttons. When you press the
UP or DOWN
temperature will change accordingly.
•
The temperature will increase 1ºF or 1ºC if you
press the UP button once. The temperature will
decrease 1ºF or 1ºC if you press the DOWN
button once. The display will flash while you
make your selection.
TEMPERATURE DISPLAY
During normal operation, the temperature display on
the control panel
temperature. The temperature display will flash if
- A different temperature is being set.
- The temperature in the zone deviates by more
than 9°F or 5°C from the set temperature.
The temperature display flashing ensures that the
temperature cannot rise or fall un-noticed.
TEMPERATURE MEMORY FUNCTION
In the event of a power interruption
breaker switch failure,
the last temperature settings and, when the power is
recovered, the cabinet temperature will go back to
the same set temperature as before the power
interruption.
TEMPERATURE ALARM
An alarm will sound if the temperature rises or falls
outside the temperature range. The temperature
display will flash at the same time.
The temperature the appliance is set at determines
the temperature the appliance recognizes as being
too warm or too cool.
buttons, the displayed
always shows the
(power surge,
etc.), the unit will remember
The alarm will sound and the temperature display
will flash:
- If the temperature inside the appliance is very
different from the temperature set. This does not
include the very first time the unit is turned on.
- When there has been a lengthy interruption to
the power supply.
- When too many items have been
unit at one time. This can be as a result of
holding the door open too long or from
overloading the unit past its recommended
capacity.
- When
THE ALARM CAN BE DEACTIVATED BY
PRESSING THE POWER BUTTON
DOOR ALARM
If the door has been left open for more than 60
seconds, the alarm will sound.
SET
Once the set temperature has been reached in the
appliance, the alarm stops and the relevant
temperature display stops flashing. However, if the
noise disturbs you, you can switch the alarm off
before this if you wish by pressing the POWER
button once. The alarm will stop. The temperature
display continues to flash until the set temperature
has been reached. The display then lights up
constantly and the alarm system is fully active again.
INTERIOR LIGHT
The interior light makes it easy to view your
beverage labels and enhances the display of your
collection. Touching the LIGHT button toggles
between 2 modes of operation for the internal lights:
functional (default) mode and showcase mode. If
you are in functional (default) mode, the lights will
turn on only when the door is open. If you are in
showcase mode, the lights will remain on whether or
not the door is open.
The unit is equipped with a LED light fitting system.
To change the LED light fitting please contact the
service department.
NOTE: Please use only the original LED light fittings
provided by the manufacturer.
10
the door is not been closed tightly.
put into the