Fagor BC-79 Manuel D'installation page 14

The door will not
close properly.
Display shows "E1".
"E2" or "E7".
The alarm sounds
and the temperature
display flashes.
The display
shows "--".
1. The appliance is not properly leveled.
2. The door was reversed and not properly
installed.
3. The gasket is dirty.
4. The shelves are out of position.
1. "E1" or "E2" indicates that the air temperature
sensor is failed.
2. E7" indicates the door switch failure.
Has the appliance door been open for longer than
60 seconds? If yes, close the door. If not, then the
temperature has risen higher or fallen lower than
the temperature that has been set. This could be
due to:
1. The appliance door being opened too often.
2. The ventilation opening being covered or too
dusty.
3. A lengthy interruption to the power supply.
4. A large amount of bottles has been added to
the unit.
1. The display temperature is out of the range.
14
1. Level the appliance with the
adjustable feet.
2. Check the door hinge and
reassemble correctly (See
Reversing the Door Hinge
section on page 8).
3. Clean the door gasket.
4.
Check the shelves and
reposition correctly.
Call for service.
1. Do not open the door more often
than necessary.
2. Clear the obstructions and clean
the dust.
3&4.Leave the appliance untouched
for a while until the set temperature
has been reached.
1. Only temperatures within the
range 16~99°F/-9~37°C will be
shown. If the temperature is not
within this range, the icon "--"
will be displayed instead. That is
normal.