Samsung 6000 Serie Manuel De L'utilisateur page 37

•
Ad-hoc: You can connect to a mobile device without an access point through the 'Samsung Wireless LAN Adapter' by
using a peer to peer network.
How to connect to new Ad-hoc
1. Choose Select a network, then a device list is displayed.
2. While in the device list, press the Blue button on the remote or select Ad-
hoc.
N
The message The existing network system may have limited
functionality. Do you want to change the network connection? is
displayed.
. Input the generated Network Name(SSID) and Security Key into the
device you want to connect.
How to connect an existing Ad-hoc device
1. Choose Select a network, the device list is displayed.
2. Select the device you want in the Device list.
. If security key was applied, input the security key again.
N
If network doesn't operate normally, please check the Network
Name(SSID) and Security Key again. If the Security Key is incorrect,
it may be the reason for the malfunction.
Wireless Network Setup-Auto Setup
If you want to connect AP, AP should support DHCP. Only devices which support Ad-hoc mode
can be connected without DHCP.
1. Set Network Type to Wireless.
2. Select Wireless Network Setup.
. Set Internet Protocol Setup to Auto Setup.
N
The Internet Protocol is set automatically.
4. Select a network through Select a network.
. Select Network Test to check the network connectivity.
Wireless Network Setup-Manual Setup
1. Set Network Type to Wireless.
2. Select Wireless Network Setup.
. Set Internet Protocol Setup to Manual Setup.
4. Set up IP Address, Subnet Mask, Gateway and DNS Server.
N
Press the number buttons on the remote control when you set the Network manually.
. Select a network through Select a network.
6. Select Network Test to check the network connectivity.
English - 
The existing network system may have limited
functionality. Do you want to change the network
connection?
Yes No
Wireless Network Setup
Internet Protocol Setup : Auto Setup ▶
Network Test
Select a network : AP1
IP Address :
Subnet Mask :
Gateway :
DNS Server :
U Move E Enter R Return
Wireless Network Setup
Internet Protocol Setup : Manual Setup ▶
Network Test
Select a network : AP1
IP Address : 0 0 0 0
Subnet Mask : 0 0 0 0
Gateway : 0 0 0 0
DNS Server : 0 0 0 0
U Move E Enter R Return