Unpacking The Generator; Overview Of The Generator - Parker UHPZN2-1000 Mode D'emploi

2.6.2 Unpacking the Generator

Once ready to install, remove the equipment from the packaging and check for signs of damage. Verify that the items listed in the table below
have been shipped with the generator.
Description
1/8" BSPP - 1/8" Tube Fitting
1/4" BSPP - 1/4" Tube Fitting
1/8" BSPP Exhaust Silencer
Dowty Seal
MIST-X Silencer Kit
UK electrical supply cable
European electrical supply cable
USA electrical supply cable
(1) The UK and European cables are supplied with the 230 Vac rated generators, and the USA cable is supplied with the 120 Vac rated generators.
If any items are missing or damaged please contact your local Parker office. Do not attempt to power up the generator.

2.6.3 Overview of the Generator

Key:
1 Pressure Relief Valve (Compressor version only)
2 Dryer Inlet pressure gauge (Non compressor version only)
3 Receiver pressure gauge
N Outlet pressure gauge
4
2
N Outlet pressure regulator
5
2
N Mass Flow Controller bypass valve.
6
2
Note. Items 1 and 5 are preset at the factory and should not be adjusted. The pressure gauges are supplied for diagnostic and indication purposes only.
6
UHPZN2
1000
1
1
1
2
1
(1)
1
1
1
7
8
9
10
11
12
13
UHPZN2 UHPZN2
1000C 3000
1 1
-- 1
1 1
1 2
1 1
1 1
1 1
1 1
Control Panel
Fused IEC320 Inlet Socket and power switch
MFC N Outlet Port
2
N Outlet Port
2
Compressed Air Inlet Port (Non compressor version only)
Drain Port
Catalyst Temperature Controller
UHPZN2
3000C
1
--
1
1
1
1
1
1