LVI TOUCH E3 Manuel D'installation Et D'utilisation page 4

FOR
UK
THE INSTALLER
TEMP. PRECISION:
ENVIRONMENTAL
CONDITIONS:
- Operating temperature
- Shipping and storage temp.
SETTING TEMPERATURE
RANGE:
- Comfort mode
- Reduced mode
- Frost protection mode
ELECTRICAL INSULATION:
ELECTRICAL PROTECTION:
RADIO FREQUENCY:
- Range outside
- Range indoor (typical)
WIFI FREQUENCY:
SOFTWARE VERSION
POWER SUPPLY
CE DIRECTIVES:
Your product has been
designed in conformity with
the European Directives.
03. Wall mounting
• Connect the power supply as described below. The electrical installation
must comply with local or national regulations. The product should be
connected by a suitable and qualified electrician.
| 4
P16MI417 - A02 - 01/16
0.1°C
-0°C to +40°C
-30°C to +50°C
+5.5°C to +30°C, must be higher than the reduced mode temperature.
+5°C to +19°C, must be lower than Comfort mode temperature.
+0.5°C to +10°C
Class II
IP 30
868 MHz, <10mW
200 m
Around 15 m
2.4 GHz (not 5.0 GHz). Touch E3 supports the following standards:
- 802.11b at 2.4Ghz- 802.11g mixed 5GHz / 2.4GHz
Note that if your router is set to this standard '802.11g mixed
5ghz / 2.4GHz' then it is mandatory to select the type of Key
to 'WPA/WP2 mixed' in order to connect in 2.4GHz with the
Microchip 2.4GHz WiFi module.
Can be found at the bottom of the Main menu: xx.xx
Can be found at the bottom right of the Wifi menu: xxxx xx.xx
85-265V 50-60 Hz
LV Directive 2006/95/EC
EMC Directive 2004/108/EC
R&TTE Directive 1999/5/EC
RoHS 2011/65/EU
NOT TO BE USED!
POWER SUPPLY 85-265V, 50/60 HZ