Installation Receiver - Radiant CLOUDWARM Manuel D'installation Et D'utilisation

1. INSTALLATION

1.1.5. INSTALLATION RECEIVER

In order for the Receiver to work via Remote Control
through Open Therm protocol, connect the cables
bearing the label "OT" to the Ta-Ta contacts of the
terminal board located inside of the control panel
of the boiler (see fig.2).
Should you intend to use the Receiver as a Room
Thermostat, connect the cables labelled "TA ON/
OFF" to the Ta-Ta contacts of the terminal board.
Connect the two contacts of the Transmitter to the
cables labelled "Thermostat" of the Receiver (see
fig.2).
Connect the plug to a power outlet (see fig.2).
Use the magnetic adhesive tape or the double.
sided adhesive tape to fix the receiver in a suitable fig. 2
place or use the fischers to secure the receiver to
the wall.
7
CLOUDWARM WIRED - RAD - ING - Manual - 1606.1