Receiver Installation; Transmitter Installation - Radiant CLOUDWARM Manuel D'installation Et D'utilisation

1. INSTALLATION

1.1.4. RECEIVER INSTALLATION

DANGER
Cut off the voltage from the main switch.
In order for the receiver to work via Remote Control
through Open Therm protocol, connect the cables
bearing the label "OT" to the Ta-Ta contacts of the
terminal board located inside of the control panel
of the boiler (see fig.1).
Should you intend to use the receiver as a Room
Thermostat, connect the cables labelled "TA ON/
OFF" to the Ta-Ta contacts of the terminal board.
Connect the plug to a power outlet.
Use the magnetic adhesive tape or the double.
sided adhesive tape to fix the receiver in a suitable
place or use the fischers to secure the receiver to fig. 1
the wall.

1.1.5. TRANSMITTER INSTALLATION

To power the transmitter, connect the micro usb
end of the cable supplied to the micro usb port of
the transmitter (see fig.2) and use the usb adapter
to connect the other end of the cable to a power
outlet.
The transmitter does not require further
connections since it works via Wireless and can be
placed in any point of the house on a safe support
base in a position suitable for measuring the
room temperature correctly, avoiding installation
in niches, behind doors, curtains, next to heat
sources, exposed to direct sunlight or water.
fig. 2
6
CLOUDWARM WIRELESS - RAD - ING - Manual- 1606.1