Samson Airline 88 Manuel Du Propriétaire page 8

Charging the AH8 Transmitter
1. Snap in place the appropriate mains connector
plug into the adapter.
2. Insert the magnetic power cable to the included
USB AC plug (or any 5-volt DC adapter that has
a USB port). Insert the AC plug into an electrical
outlet.
3. Place the AH8 transmitter on a flat surface.
4. Attach the magnetic connector to the gold
contact power port on the bottom of the AH8
transmitter. The cable attaches to the port
magnetically.
The magnetic connector is keyed so it will only
connect in one direction.
Note: Transmission is disabled during charging.
5. Look at the indicator light on the AH8
transmitter to determine when the transmitter
has finished charging. When the light is flashing
red, the AH8 is charging. When the red light
stops flashing it indicates that the AH8 is fully
charged.
6. Disconnect the magnetic power cable from the
AH8 when the unit is fully charged.
If you notice your AH8 battery life is becoming
shorter after a full charge, you can order a user
replaceable battery from your local Samson
distributer.
Getting the most out of the rechargeable battery:
• Completely charge the batteries before first use
• Fully charge the battery before it will be used.
• After the battery is charged, unplug the charger from the outlet or
remove the battery from the charger.
• The optimal temperature range for using and storing the battery is
50°F - 86°F (30°C - 50°C). The battery performance and operation
may decrease in temperatures below 50°F (30°C).
A warning that batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type attention should be drawn to the environmental aspects
of battery disposal
8