Samson Airline 88 Manuel Du Propriétaire page 6

Quick Start
Position the transmitter about 6-12" (15-30 cm) from the front of the CR88 with
the transmitter's IR window facing the IR transmitter on the front panel of the CR88
receiver.
Press and hold the CR88 SELECT button to set the transmitter to the same channel
as the receiver via infrared transmission. The CR88 display will flash while the
receiver is sending the operating channel.
5. Plug receiver into audio system
9. Press and hold SELECT button to IR set
Note: The AH8 will only accept infrared transmission from the receiver for
the first 10 seconds after the AH8 is powered on. If you need to change
the operating channel, the AH8 must be first powered off, then powered
on again to receive the new channel.
When the transmission is complete, the CR88
will receive RF signal from the transmitter.
The READY indicator will light on the front
panel of the CR88 receiver.
Turn on your connected amplifier or mixer, but
keep the volume all the way down. Set the
Volume knob on the CR88 fully clockwise (to
its "10" setting). This is unity gain.
Speak or sing into the microphone. Slowly
raise the volume of your amplifier or mixer
until the desired level is reached.
If you find the system has noticeable
dropouts, reduced overall working range,
or unexpected noise bursts, change the
operating channel of the system using the
steps above.
6
9. Press and hold SELECT button to IR set
interference, and
FREQ:
(2) this device must accept any
542-566MHz
interference received, including
interference that may cause
undesired operation.
6. Press Select button to change c
10. Adjust Volume control
10. Adjust Volume control