Loop Function; Audio Recording - Hama Dashcam 30 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
• Navigate to the Motion detectionmenu item and confirm your selection by pressing [OK] (7). A new
overview window opens.
• Use the navigation buttons [◄] (9) / [►] (5) to select the desired setting.
• Confirm your selection by pressing [OK] (7).
is shown on the video display.

9.1.4 Loop function

Select the time interval (1/2/3/5 minutes) after which a new video recording should begin.
Select Off to deactivate this function. Now only one file will be created.
• Navigate to the Loop functionmenu item and confirm your selection by pressing [OK] (7). A new
overview window opens.
• Use the navigation buttons [◄] (9) / [►] (5) to select the desired setting.
• Confirm your selection by pressing [OK] (7).
is shown on the video display.

9.1.5 Audio recording

With the mode activated, sound is recorded in addition to the video material.
• Navigate to the Audio recordingmenu item and confirm your selection by pressing [OK] (7). A new
overview window opens.
• Use the navigation buttons [◄] (9) / [►] (5) to select the desired setting.
• Confirm your selection by pressing [OK] (7).
9.1.6 Contrast
Improve the quality of the video recording through contrast adjustment (-2 to +2).
• Navigate to the Contrast menu item and confirm your selection by pressing [OK] (7). A new
overview window opens.
• Use the navigation buttons [◄] (9) / [►] (5) to select the desired setting.
• Confirm your selection by pressing [OK] (7).
9.2 Photo mode settings
• Switch to Photo mode as described in section 8.2 Photo mode.
• Press [MENU] (8) to go to the photo settings.
is shown at the upper-left edge of the screen.
• Use the navigation buttons [◄] (9) / [►] (5) to navigate through the menu.
• Confirm your selection by pressing [OK] (7).
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

00136697

Table des Matières