Diagnostiques - Fortin MS3 Guide D'installation

MS3
DIAGNOSTICS
Led Display
1x Red, 1x Green, 1x Blue
Fast Purple Blink
Fast Amber Blink
1x Constant Amber Blink
2x Constant Amber Blink
7x Amber Blink
1x Green Blink
1x Amber Blink
État de la Del
1x Rouge, 1x Verte, 1x Bleue Séquence de démarrage
Clignotement Rapide Mauve
Clignotement Rapide Ambre Réinitialisation d'origine
1x Clignotement Ambre
Constant
Page 6 / 16
Event
Boot Sequence
Installer Mode for Validation testing
Factory Reset
Unable to sync with Digital Remote
MS3
starter during power-up
Validation pending
(make sure that the MS3
yellow (+) ignition wire is properly connected to
the vehicle's (+) ignition wire.)
Pit-Stop Mode Not Available
Command sent to Remote starter
succeeded
Command sent to Remote starter failed
Évenement
Mode installateur pour faire la
Validation
Incapable de syncroniser avec le
démarreur a distance digital durant
la mise sous tension du MS3.

DIAGNOSTIQUES

Action
N/A
Cycle ignition OFF to send an Unlock command
Restart MS3 programming
Disconnect and Re-connect MS3 main harness.
Verify Protocol selection.
Perform Validation Step:
a. Disconnect the
b. Cycle ignition to the ON position
c. Re-Connect the
programming button)
d. The LED will blink Purple rapidly for 15
seconds
e. During this period, Cycle ignition to the OFF
position
f. If the vehicle door's unlocks, your
programming is successful.
Shutdown and Restart vehicle's engine and
retry Pit-stop mode and/or wrong DATA-LINK
communication port
Remote starter will execute the command sent
from MS3 unit
Verify MS3 protocol selection and/or wrong
DATA-LINK communication port
Action
N/A
Mettre l'ignition a la position OFF pour
envoyer une commande de Déverrouillage
Refaire la programmation du module MS3
Débrancher et Re-brancher le harnais
principal du module MS3. Véerifi er la
sélection du protocol
Page 6 / 8
MS3
unit
MS3
unit (DO NOT Press the