4.4 Cable Gland - Minebea Intec Cable Junction Box PR 6130/68S Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cable Junction Box PR 6130/68S

4.4 Cable gland

Minebea Intec
The cables have to be fed into the device via glands to ensure leak-tightness. The
following cable diameters are suitable: 6…12 mm for gland M20 and 3…6 mm for cable
gland M12.
The enclosed M20 cable gland is suitable for cable diameters 9…13 mm.
The cable wires are connected to the terminals inside the device.
NOTICE
For protection against dust and moisture during transport and installation, the
cable glands are fitted with a polyethylene cover.
For full IP protection, operation with the dust protection cover fitted is not permitted.
Remove the dust protection cover.
If a cable gland is not used, it must be sealed with a supplied locking pin.
NOTICE
Property damage is possible.
Regularly check the fitted cable gland for tightness and re-tighten it, if necessary.
4 Installation and connection information
EN-14

Publicité

Table des Matières
loading

Table des Matières