Rapid 90EC Manuel D'utilisation page 6

LOADING
Depress the magazine lock. The magazine can
then be pulled out. After loading, push home the
magazine. The magazine will then be automatical-
ly locked in its home position.
STAPLING
Rapid 90EC staples automatically when the object
to be stapled is entered in the machine jaws and
actuates the trigger. The stapling depth, i.e. the
position in which the staples are inserted, can be
adjusted by moving the trigger. Depress the control
on the lefthand side of the machine and move it to
the desired position on the scale.
The scale presents the distance between the sta-
ple and the edge of the paper. To change the anvil
to outword stapling:
Press the pin just under the anvil on the bottom of
the stapler and turn 180°.
OPERATIONAL DISTURBANCES
Rapid 90EC is designed to withstand intensive
and lengthy operation. Should operational distur-
bances occur despite this, the cause must be
investigated.
DISTURBANCE CAUSE/ACTION
1. The staple is not Check that the correct staple
bent sufficiently. type is being used. See the
designation on the front of
the magazine.
The object is too thick. The
magazine is designed for
about 30 sheets of 80 g
paper (approx. 3 mm). If
thicker objects are inserted,
the staple legs will not be
sufficiently long for bending.
The object is too hard.
The machine is worn and
should be sent in for service.
2. Working stroke Check that the magazine is
is triggered but loaded with staples.
machine does
not staple. Check that the right staple
type is used.
If a staple gets stuck in the
outlet it can be removed with
the aid of a loose staple. Do
not use a screwdriver, a knife
or the like since this may
damage the machine.
3. Working stroke is Check that the machine is
not triggered.
Do not staple hard objects such as metal.
Do not let the machine work
This will cause unnecessary wear.
Do not use the machine with a damaged connec-
tion cable or plug.
Length: 245 mm
Width: 113 mm
Height: 118 mm
Weight: 1,9 kg
Capacity: 30 sheets
Stapling depth: 60 mm
Staple type: See front of magazine
RAPID 90EC
dB(A)
85
80
75
70
65
60
55
50
15000 1500
Equivalent noise level dB(A) at maximum capacity
and power.
Ex. 910 staples per 8 hours give 70dB(A) (90EC).
Noise measurement made according to ISO 7779
with supplement proposal "Electrical staplers:
Noise test code".
The 70 dB(A) equivalent noise level is a German
requirement for maximum noise level in common
areas such as shops, airport check in, receptions
and other simular areas.
4
If the machine has been
damaged or is worn out it
should be sent back to the
supplier for service.
properly connected.
Check that power is supplied
in the wall socket. A fuse
may have blown.
Check that the trigger can
move backwards and for-
wards.
If none of these faults occur,
send in the machine to the
supplier for service.
without staples.
150 15
910 STAPLES/8h
GB