Würth AMTS 18 L COMPACT Traduction Des Instructions De Service D'origine page 21

Cleaning the electrodes (22)
1. Unlock and remove the suction head [2].
2. Clean the electrodes [22] using a brush.
3. Insert the suction head [2] and secure it with the
locks [3].
Troubleshooting
Note
In case of a failure (e.g. filter frame
breakage) the appliance must be turned
off immediately. The failure must be
remedied before the appliance is put
into operation again.
Suction motor is not running
▸
Check that the battery is not discharged and
properly inserted.
▸
Switch the device on.
▸
The motor may have overheated. Switch the
device off and wait 10–15 minutes until it has
cooled down. Wait until this period is over before
switching on again.
Suction turbine switches off
▸
Empty the container [1].
▸
The motor may have overheated. Switch the
device off and wait 10–15 minutes until it has
cooled down. Wait until this period is over before
switching on again.
After emptying the container the suc-
tion turbine does not start up again
▸
Turn off the appliance and wait for 5 seconds,
then turn it on again.
▸
Clean the electrodes [22] and the area around
them using a brush.
Suction capacity decreases
▸
Remove blockages in the suction nozzle [5],
hose cuff [8] suction hose [16], or flat-folded
filter [19].
▸
Replace the full filter bag [21].
▸
Ensure the flat-folded filter [19] is properly fixed
and locked into place.
▸
Replace the flat-folded filter [19].
Dust comes out of the device while
vacuuming
▸
Check the position of the flat-folded filter [19]
and correct if necessary.
▸
Replace the flat-folded filter [19].
Electric shocks
As with any other vacuum appliance, when sucking
fine dust, static electricity can be generated causing
small electrical shocks when touching the hose. This
can occur especially if the environment is too dry.
One way of avoiding is to add moisture to air by
using a humidifier.
Please note that this situation will not have any effect
on use of the vacuum cleaner.
If a malfunction cannot be fixed, the
device must be checked by customer
service.
Accessories and spare parts
If, in spite of careful manufacturing and testing
processes, the device becomes faulty, a repair by
Würth masterService should be arranged. With any
enquiries or spare parts orders, always quote the
article number as given on the name plate.
The latest spare parts list for the device is available
online at http://www.wuerth.com/partsmanager.
Alternatively, contact your local Würth agency for a
hardcopy.
Disposal
Do not dispose of this device with
normal household waste. Dispose of
the device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regulations. In case of
doubt, contact your waste disposal facility. Dispose
of all packaging in an environmentally sound
manner.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note). Damage that has
occurred will be corrected either by replacement or
by repair. Damage caused by improper handling is
not covered by the warranty. Claims under warranty
can only be accepted if the device is returned fully
assembled to a Würth agency, your Würth sales
representative or an authorised Würth customer
service workshop. We reserve the right to make
technical changes. We accept no liability for printing
errors.
21