Samsung NX58 9420S Série Mode D'emploi page 40

Maintenance
How to re-install the door
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentations
of the hinge arms into the bottom edges of the hinge slots. The notches in each
hinge arm must be fully inserted into the bottoms of each slot.
Bottom edge of slot
Hinge arm
Indentation
3. Open the door fully. If the door will not open fully, the indentations are not
inserted correctly in the bottom edges of each slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
5. Close the oven door.
40 English
NX58M9420S_DG68-00905A-05_EN+MES+CFR.indb 40
Hinge lock
Locked position Unlocked position
How to remove and re-install the Storage drawer
Storage drawer
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
3. Clean the drawer in warm, soapy water
4. Put the drawer in the roller guides on
side. Using both hands, pull down the left
clip while lifting the right clip, and then
remove the drawer.
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
either side, and then snap the clips into
place.
2018-08-29 4:58:29