Samsung NX58 9420S Série Mode D'emploi page 37

To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
2
1. Make sure the oven door is closed completely and unlocked.
2. Press the Self Clean pad once. Then, select the cleaning time by pressing the Self
Clean pad one or more times in accordance with the table below.
Once
3-hour cycle
3. Press the START/SET pad. The oven door is locked and the oven begins to heat
up.
4. When the self-cleaning cycle is complete, the oven beeps 10 times. The door
will remain locked and the Lock icon will blink until the oven temperature falls
below 400 °F (204 °C).
5. When the Lock icon changes to an open lock, you can open the oven door. The
Lock icon changes to an open lock when the oven temperature drops below
400 °F (204 °C).
6. Press the OFF/CLEAR pad to display the time of the day.
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.
WARNING
Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.
NX58M9420S_DG68-00905A-05_EN+MES+CFR.indb 37
Twice Three times
5-hour cycle 2-hour cycle
3
6
To delay starting a self-cleaning cycle
1. Repeat steps 1 and 2 from the column on the left.
2. Press the Delay Start pad. The oven door locks.
3. Set the time you want the oven to start self-cleaning using the number pad.
4. Press the START/SET pad. The oven will start self-cleaning at your specified
time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke
in the oven. To turn off the self-cleaning cycle, press the OFF/CLEAR pad. The
cycle turns off, but the door remains locked and the Lock icon blinks until the oven
temperature falls below 400 °F (204 °C).
NOTE
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
3 4
2
English 37
2018-08-29 4:58:28