Operating Instructions; Using The Water Softening System (On Some Models Only) - Fulgor Milano F6DW24 SS1 Mode D'emploi

EN
5
5.1
The amount of scale contained in the water (water hardness index) can cause whit-
ish on the dry dishes, which tend to become dull over time. The dishwasher is
equipped with an automatic softening system which uses a special regenerat-
ing salt to reduce the hardness of the water. The dishwasher is factory set for water
hardness level 3 (average hardness 41-60°dF – 24-31°dH / 23.6-35 gpg). When us-
ing water of medium hardness, the regenerating salt container should be refilled
after approximately 20 washing cycles. The salt container can hold approximately
1.7 Kg (3.75 lb) of salt in grains. Some models are equipped with an optical no-salt
indicator. In these models, the cap of the salt container contains a green float which
descends as the salt concentration in the water drops. When the green float can no
longer be seen, the container must be topped up with regenerating salt. The con-
tainer is situated at the bottom of the dishwasher. After removing the lower rack,
unscrew the salt container cap (ref. A fig.
pour in the salt using the funnel (
Before replacing the cap (ref. A fig.
the opening.
18
USER INSTRUCTIONS

OPERATING INSTRUCTIONS

BEFORE STARTING TO USE THE APPLIANCE, MAKE SURE YOU HAVE
READ AND UNDERSTOOD ALL THE WARNINGS CONTAINED IN CHAP-
TER "IMPORTANT SAFETY INSTRUCTION ".
Using the water softening system
) by turning it anticlockwise and
) supplied with the dishwasher.
), remove any salt residues from around
A