Cleaning Tips; Installation Of The Appliance; Installation Safety; Fitting The Hob Into A Worktop - Sharp KH-6I19BS00-EU Guide D'utilisation

Cleaning tips

· Do not use abrasive pads, corrosive
cleaners, aerosol cleaners or sharp
objects to clean the surfaces of the
hob.
· To remove burnt food, soak it off with
a damp cloth and washing-up liquid.
· You may use a scraper for cleaning
food or residues. Sticky foods must be
cleaned immediately when they spill,
before the glass has cooled down.
· Be careful not to scratch the silicon
adhesive placed on the edges of the
glass whilst using a scraper.
· The scraper has a razor, therefore, it
must be kept away from children.
· Use a special ceramic hob cleaner
on the hob while it is warm to touch.
Rinse and wipe dry with a clean cloth
or paper towel.
INSTALLATION OF THE
APPLIANCE
WARNING:
The electrical connection of this hob
should be carried out by a qualified
electrician, according to the instructions
in this guide and in compliance with
the current regulations. In the event
of any damage that occurs as a result
of improper connection or installation,
the warranty will not be valid. This
appliance must be grounded.

Installation safety

· Any overhanging surface should be
at least 65cm above the hob.
· Extractor fans must be fitted in
accordance with the manufacturer's
instructions.
· The wall in contact with the rear of
the hob must be made of flameproof
material.
· The power cable length should not
exceed 2 metres.
Fitting the hob into a work
surface
· The hob can be inserted into any
worktop provided it is heat resistant up
to at least 90ºC.
· Create an opening with the
dimensions shown in the picture
below and on the next page.
· The induction hob may be built in 25
to 40 mm thick worktops.
PRODUCT DIMENSION
EN
W (mm) D (mm) H (mm)
590 520
53