Machine Transport And Handling; Packing Removal And Machine Positioning; Packing Removal; Machine Positioning - Keyfrost KBS Manuel

1.1 Machine transport and handling

The machines are protected during transport by particularly sturdy packing which is resistant to various stresses.
In spite of its low dimensions the packaged machine cannot be transported manually.
The correct lifting system to use is a fork lift or pallet conveyor/mover, making sure that the weight of the machine is evenly distributed.
For highest safety during transport and handling, the equipment contained inside the packing has been screwed down to the pallet.
The packing has printed warning symbols that represent the instructions to follow during transport and storage in order to assure that no
damage is caused to the equipment during loading and unloading operations
The symbols printed on our packing are as follows (UNI ISO 780):
HANDLE WITH CARE THIS WAY UP

1.2 Packing removal and machine positioning

We recommend unpacking the equipment as soon as it arrives in order to verify that it is complete and that it has not been damaged
during transport. Damage, if any, must be communicated immediately to the carrier, even in the event that such damage is only found
during installation. Damaged equipment may not, under any circumstances, be returned to the manufacturer without prior to written
warning and without the manufacturer's written consent.

Packing Removal

1.2.1
For correct removal of packing, follow the sequence of steps (1-5), using the following tools:
- screwdriver.
1
1

Machine positioning

1.2.2
For a correct operation of the machine, we recommend, when positioning the machine, that you:
- Place the cold room in an area that is well ventilated continuously and well away from all sources of heat.
- Do not install the machine on outside cold rooms.
- Check that the panels of the cold room are perfectly level.
- Place the machine in an easily accessible position, in order to facilitate inspections and maintenance operations.
- Place the machine in a zone where the most uniform cold distribution is possible.
- Ensure that the spaces around the air suction and exhaust grids of the machine are not blocked or reduced in size in any way.
(fig.1.2.2).
THIS MACHINE IS NOT DESIGNED FOR INSTALLATION IN ENVIRONMENTS WITH A POTENTIALLY EXPLOSIVE ATMOSPHERE.
Manual
PROTECT FROM MOISTURE
2 3
2 3
FORK HERE
4 5
17