Dremel 4300 Consignes De Fonctionnement/Sécurité page 26

1600A00N3H.qxp_4300 7/8/16 10:34 AM Page 26
EZ Drum™ Mandrel No. EZ407SA has a
spring loaded sleeve and is used with
sanding bands.
before changing accessories. Incorrect
seating of sanding band on mandrel may
lead to personal injury orproperty damage.
To load accessory:
1. As indicated, place two fingers underneath
the mandrel and pull firmly up. This will
place the EZ Drum™ in the "unlocked"
position (Fig. 1).
2. Keeping two fingers beneath the mandrel,
slide the sanding band down until the
entire blue mandrel is covered (Fig. 2).
3. To return to "locked" position, press firmly
down on the top of the mandrel (Fig. 3).
Removing the sanding band on
the mandrel:
1. Place two fingers underneath the mandrel
and pull firmly up. This will place the EZ
Drum™ in the "unlocked" position (Fig. 1).
2. Sanding band will now easily slide off
mandrel (Fig. 2). Do not squeeze sanding
band when removing from EZ Drum™
mandrel. This can lead to rubber band
pulling off mandrel and becoming
inoperable.
26
EZ Drum Operating Instructions
™
Always make sure the
rotary tool is "OFF"
FIG. 1
FIG. 2
FIG. 3