Dremel 4300 Consignes De Fonctionnement/Sécurité page 22

1600A00N3H.qxp_4300 7/8/16 10:33 AM Page 22
cult places, and other sanding jobs. You
replace the sanding bands on the drum as
they become worn and lose their grit. Bands
come in fine medium and coarse grades.
Flapwheels grind and polish flat or contoured
surfaces. They are used most effectively as a
finishing sander after heavier surface
sanding and material removal is completed.
Flapwheels come in fine and coarse grades.
Buffs are a great finishing accessory for
cleaning and light sanding. They work
effectively on metal, glass, wood, aluminum
and plastics. Coarse and medium buffs are
sold together. All buffs are sold individually.
Do not exceed 15,000 RPM in speed. 1/8"
shank.
Grinding Wheel
Use for deburring, removing rust, and general
purpose grinding. Use with Mandrel #402.
Cutting Wheels
These thin discs of emery or fiberglass are
used for slicing, cutting off and similar
operations. Use them for cutting off frozen
bolt heads and nuts, or to reslot a screw
head which has become so damaged that
the screwdriver won't work in it. Fine for
cutting BX cable, small rods, tubing, cable
and cutting rectangular holes in sheet metal.
Drywall Cutting Bit
Gives you fast, clean cuts in drywall. Use
with Dremel No 565/566 Cutting Guide
attachment.
22
Dremel Accessories (Continued)
Tile Cutting Bit
Cuts ceramic wall tile, cement board, and
plaster. Use with Dremel No 565/566 Cutting
Guide attachment.
Spiral Cutting Bit
Cuts through all types of wood and wood
composites. Use with Dremel No 565/566
Cutting Guide attachment.
High Speed Router Bits
For routing, inlaying, and mortising in wood
and other soft materials. Use with Dremel
No. 335 Router attachment and No. 231
Shaper/Router table.
Brad Point Drill Bits
Titanium coated brad points stay on center
and begin drilling immediately. For use on
wood. Size 1/8", 5/32", 3/16", ¼" . 1/8" shank.
HSS Drill Bits
HSS drill bit for use in metal and plastic. Size
1/8", 7/64", 3/32", 5/64", 1/16", 3/64", 1/32".
Shank size matches the drill bit size.
Different collet size (481, 482, 483) or
Dremel chuck (4486) required according to
drill bit being used.