Fein STS325R Mode D'emploi page 8

OBJ_BUCH-0000000116-003.book Page 8 Tuesday, December 6, 2016 11:00 AM
en
8
Symbols.
Symbol, character Explanation
Make sure to read the enclosed documents such as the Instruction
Manual and the General Safety Instructions.
Observe the instructions in the text or graphic opposite!
Do not touch the saw blade
Disconnect the energy supply prior to this work step. Otherwise there
may be danger of injury caused by unintentional starting of the pneu-
matic tool.
Use eye protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
A surface that can be touched may be very hot and thus hazardous.
This symbol confirms the certification of this product for the USA and
Canada.
This sign warns of a directly imminent, dangerous situation. A false
DANGER
reaction can cause a severe or fatal injury.
This sign indicates a possible dangerous situation that could cause severe
WARNING
or fatal injury.
This sign warns of a possible dangerous situation that could cause injury.
CAUTION
Pneumatic tools and other electro-technical and electrical products
taken out of service should be collected separately and sorted for
environment-friendly recycling.
Steel
(**) may contain numbers and letters
Character Unit of measurement,
national
n rpm; /min; min
0
P W
°
U
V
f
Hz
I
A
m
kg, lbs
l
ft, in
Ø ft, in
m, s, kg, A, mm, V, W,
Hz, N, °C, dB, min, m/s
Explanation
-1
; r/min Stroke rate at no-load
Unit of measure for power
Angle width
Unit of measure for voltage
Frequency
Unit of measure for current
Mass
Length, width, height, depth, diameter or thread
Diameter of a round part
Basic and derived units of measurement from the
2
international system of units SI.