Fein STS325R Mode D'emploi page 12

OBJ_BUCH-0000000116-003.book Page 12 Tuesday, December 6, 2016 11:00 AM
en
12
Working instructions.
Disconnect the energy supply before making any pneumatic tool adjustments,
WARNING
changing accessories, or placing the pneumatic tool aside. This precaution pre-
vents accidental starting of the tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off (figure 4).
Always hold the pneumatic
CAUTION
tool firmly. Otherwise, you
can lose control over the pneumatic tool.
Apply the pneumatic tool to the work
piece only when switched on.
Guide the pneumatic tool uniformly and with
light feed in the cutting direction. Excessive
feed reduces the tool life of the application
tools.
Switching on:
Press the On/Off switch. The stroke rate is
raised with increasing pressure against the
On/Off switch (I).
– low stroke rate for working aluminum and
plastics,
– high stroke rate for working steel.
Switching off:
Release the On/Off switch ().
To increase the tool life of the saw blade
when sawing metal, it is recommended to use
a lubricating agent:
– For cuts in steel sheet: cutting oil
– For cuts in aluminum: petroleum.
As an alternative, cutting paste can also be
applied to the cutting line.
When uncoupling hose couplings, first shut
the ball valve, then actuate the pneumatic
tool, and then uncouple. Do not uncouple the
hose coupling until after the compressed air
has been completely relieved.
Fig. 4
1.
2.