Easypix DVC 5016 HD Mode D'emploi page 19

When using the camcorder:
Problem
Cannot use the fl ash strobe.
The camcorder does not
respond to any action during
operation.
The recorded pictures appear
too blurred.
The recorded pictures or
video clips appear too dark.
Noises occur when viewing
images on the LCD screen or
on the computer.
I want to restart the se-
rial number of the file name
(IMG_xxxx).
I convert a media fi le and
name it as IMG_xxxx.* (xxxx
indicates number). Then I
copy the fi le to the camcorder
but cannot fi nd it on the
camcorder.
Cause
If the battery icon indicates
low battery, the fl ash strobe
may be disabled due to insuf-
fi cient voltage.
The camcorder encounters
software failure.
The focus is not correctly set.
The environment of shooting
or recording does not have
adequate light.
The fl icker setting does not
match the standard of the
country you are staying.
The counting of the serial
number is handled by the
camcorder firmware.
There is another fi le with
duplicate serial number
(e.g. IMG_0001.MP4 and
IMG_0001.JPG), or the fi le
type is not supported.
17
Solution
Replace the battery.
Remove the battery pack and
replace it into the compart-
ment. Then power on the
camcorder.
Adjust the focus to an ap-
propriate position.
Use fl ash strobe when taking
pictures. Add extra light
sources when recording
video clips.
Adjust the fl icker setting. For
more information, please
refer to the "Flicker Settings"
table.
Use the camcorder "Format"
function to format the card.
Give the fi le a distinctive
serial number and make sure
the fi le type is supported by
the camcorder.