emerio SI-110298.4 Mode D'emploi page 7

Steam ironing can be used in the temperature ranges ●, ●●, ●●● MAX. For the reliable functioning of the
steam ironing, the water tank must be at least 1/4 filled.
Spraying function: Press the spray button to moisten a spot to be ironed. Water will come out of the spray
nozzle.
Steam Function: Turn the steam control knob to the required position
holes in the soleplate.
Burst of steam: Turn the temperature regulator to the position "MAX". The indicator light will go off when the
required temperature is reached. Then press the burst of steam button. This function provides an extra amount
of steam to remove stubborn wrinkles. For optimal use, please allow the appliance to have a rest of 3 - 5
seconds between each press.
"Burst of steam" can also be applied when holding the iron in vertical position, which is useful for removing
creases from hanging clothes, curtains, etc.
The iron surface must always be kept in an upright position.
To turn off, turn the temperature regulator counter-clockwise to "OFF" and pull out the power plug.
Turn the appliance upside down and carefully pour the remaining water out of the water tank. Carefully shake
the appliance.
Press the spray button to allow possible remaining water to come out more easily.
Notice: With conventional steam ironing, water may leak from the soleplate if a too low temperature has been
selected. If this happens, turn the temperature regulator to the ●●● MAX position. Steam will recommence as
soon as the appropriate temperature has been reached.
SELF-CLEAN FUNCTION
You can use the self-clean function to remove scale and impurities.
The self-clean function should be used at least once per month.
If the water is very hard in your area, use the self-clean function every two weeks.

Fill the water tank with water to maximum level.

Switch the temperature regulator to the ●●● MAX position.

Plug the appliance into an appropriate plug socket.

When the indicator light turns off, unplug the appliance.

Hold the iron over the sink, set the steam control knob to the position
about one minute. The appliance will conduct self-cleaning. (Steam and boiling water will come out of the
soleplate. Impurities and flakes (if any) will be flushed out).
If the iron still contains a lot of impurities, repeat the self-clean process as long as there is water in water tank.
CLEANING AND MAINTENANCE
Before cleaning the iron ensure it is disconnected from the power supply and has completely cooled

down.
Deposits on the soleplate may be removed with a rough cloth soaked in a vinegar water solution.

The casting may be wiped with a damp cloth and then polished with a dry one.

Do not use abrasives on the soleplate.

Keep the soleplate smooth. Avoid hard contact with metal objects.

- 6 -
, steam starts coming out from the
and hold it at the position for