Connection - Kenwood DNX9980HD Guide De Démarrage Rapide

Connection

Ignition key
switch
Car fuse box
Car fuse box
(Main fuse)
A
Battery
⁄
Connect to the vehicle's parking
brake detection switch harness.
Light Green (Parking sensor wire)
⁄
To use the steering wheel remote control feature, you need
an exclusive remote adapter (not supplied) matched to your
car.
either the telephone rings or during conversation.
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
⁄
If no connections are made, do not let the cable come out from the tab.
22 | Quick Start Guide
¤
Installation of this unit requires skills and experience so leave the
mounting and wiring to professionals. When the unit is being
installed the wiring should be connected via the vehicles' fuse box
ensuring the correct amperage is used. Failure to do so may result in
damage to the unit and/or the vehicle or may result in fire, etc.
ACC
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
- (To car chassis)
A
PRK SW
For safety reasons, be sure to connect the parking sensor.
Connect to vehicle's reverse lamp harness
when using the optional rear view camera.
To car light control switch
Connect to the terminal that is grounded when
Depending on what antenna you are using,
When using the optional power amplifier,
connect to its power control terminal.
Antenna Cord
To steering remote
FM/AM antenna input